Frequently Asked Questions
 

How does Southland Sensing’s precision oxygen sensor work?The sensors are electrochemical devices which generate a current signal output (typically uA) that is proportional to the amount of oxygen present in the application. When no oxygen is present, the output has a theoretical value of zero. Once oxygen from the application diffuses into the membrane, a signal is generated through a chemical reaction that occurs between the anode, cathode and electrolyte solution.

What is the difference between ppm (trace) and percent oxygen sensors?The main difference between the two measurement ranges is the amount of oxygen present. One can easily convert back and forth between the two, 20.9% is equal to 209,000 ppm of oxygen. PPM or trace oxygen sensors are usually used when oxygen is measured at less than 1000 ppm.

How does CO2 (Carbon Dioxide) and H2S gas affect the sensor life? CO2 and H2S gas can have an adverse effect on the life of our oxygen sensors. If you have an application that might contain CO2 or H2S, please contact a sales representative and ask for our recommendations. In most cases, we can offer another sensor model or sample system recommendation to negate the problem.

What is the recommended temperature range of the oxygen sensor? All sensors are rated at 0°C (32°F) to 50°C (122°F)

How does change in temperature influence the oxygen sensor's performance? Temperature influences the signal output at the rate of 2.54% per °C. Compensation is recommended.

Can liquid or moisture affect the reading of the oxygen sensors? Moisture does not damage the sensor, however build up of excess moisture can block the gas flow. Another issue to monitor is that moisture and other types of corrosive liquids can damage the electrical connections of the sensor rendering it non-responsive.

Is there a recommended load for the sensors when developing an OEM circuit board? The maximum load is a flat 10K, however no load is recommended. It is also worthwhile to note that the sensors cannot handle a reverse current flow.

How do I calibrate an oxygen sensor, how often should I calibrate it? Calibration is recommended by using a certified span gas in the range of analysis. We recommend sourcing an O2 mixture that falls into the 80 – 100% of the range you are using. Calibration should be in intervals of 2 – 3 months or as required by your application.

How long can I store the sensors? We recommend keeping them on the shelf for no longer than 6 months for most of our sensors. Check with a sales representative for more information.